Danfoss ECL Comfort User Manual page 60

32l
Service parameter(s) 66
66 Compensation temperature influence -
2. point, min. limitation
Circuit
I
Set the influence from the compensation temperature on the
desired balance / flow temperature.
Set the influence from the compensation
temperature (set in line 64).
Influence higher than 0:
The desired balance / flow temperature is
increased, when the compensation temperature
falls below the set limit.
Influence lower than 0:
The desired balance / flow temperature is
decreased, when the compensation temperature
falls below the set limit.
Influence
0
Example:
The compensation temperature limit at 2. point is set to 5 °C.
The influence is set to 2.
The actual compensation temperature (S1) is 2 degrees too low.
Result:
The desired balance / flow temperature is changed by 2 x 2 = 4
degrees.
The grey
side of the
ECL Card
Setting range
-9.9 ... 0 ... 9.9
Min. limitation > 0
Factory setting
Compensation temp.
2. point
Min. limitation < 0
0.0