Danfoss ECL Comfort User Manual page 49

Service parameter(s) 10-15
10 Choice of room panel / remote control
Circuit
I
Decides the communication with the room panel or remote
control.
Please note that the room panel / remote control is only active if
the system device bus is active. The bus is active when the address
15 is chosen in line 199.
Choose between
0:
1:
2:
3 ... 5: Not used
15 Adaptive function of room temperature
Circuit
(I) / (II)
Controls how fast the room temperature adapts to the desired
room temperature.
The adaptive funtion will eliminate the difference
between the desired and the actual room
temperature. This is done by integrating the
difference and adjusting the desired flow
temperature.
OFF: The adaptive funtion is cancelled.
1:
30:
Setting range
No room panel / remote control
Room panel ECA 60 / 62 or remote control
ECA 61 / 63 with address A
Room panel ECA 60 / 62 or remote control
ECA 61 / 63 with address B
Setting range
OFF / 1 ... 30
The desired temperature is adapted quickly.
The desired temperature is adapted slowly.
0 ... 5
32a
Factory setting
0
Factory setting
(OFF) / (OFF)
The grey
side of the
ECL Card