Danfoss ECL Comfort User Manual page 53

Service parameter(s) 36
36 Limitation temperature influence, min.
Circuit
I
Set the influence from the limitation temperature on the desired
balance / flow temperature.
Set the influence of the min. limitation
temperature (set in line 30).
Influence higher than 0 :
The desired flow temperature / balance
temperature is increased, when the limitation
temperature gets below the set limit.
Influence lower than 0:
The desired flow temperature / balance
temperature is decreased, when the limitation
temperature gets below the set limit.
Influence
0
Example
The limitation temperature is set to 50 °C.
The influence is set to 2.0.
The actual limitation temperature is 2 degrees too low.
Result:
The desired flow temperature / balance temperature is changed
by 2.0 x 2 = 4 degrees.
Setting range
-9.9 ... 0 ... 9.9
Min. limitation > 0
Min. limitation < 0
Factory setting
Limit Limitation temp.
The grey
side of the
ECL Card
32e
0.0