Danfoss ECL Comfort User Manual page 51

Service parameter(s) 25-30
25 Relay 1 (R1) function related to room temperature
Circuit
I
Decide the function of relay 1 (R1).
ON: P1 (pump or fan) is OFF when:
OFF: P1 (pump or fan) is controlled without any
This function is only active in application type 0 (line 85).
30 Limitation temperature, sensor S4
Circuit
I
Set the limitation temperature at S4.
Set the limitation temperature.
When the temperature at S4 falls below or gets higher
than the set value, the desired flow temperature / balance
temperature is changed. The changes are set in lines 35 and
36.
The limitation is only active during heating mode.
Setting range
ON / OFF
• the room temperature is one degree
higher than the desired room
temperature and
• the min. flow temperature limitation is
reached (line 2).
room temperature influence.
Setting range
10 ... 110 °C
32c
Factory setting
OFF
Factory setting
25 °C
The grey
side of the
ECL Card