Danfoss ECL Comfort User Manual page 59

Service parameter(s) 65
65 Compensation temperature influence, 2. point,
max. limitation
Circuit
I
Set the influence from the compensation temperature on the
desired balance / flow temperature.
Set the influence from the compensation
temperature (set in line 64).
Influence higher than 0:
The desired balance / flow temperature is
increased, when the compensation temperature
gets higher than the 2. point.
Influence lower than 0:
The desired balance / flow temperature is
decreased, when the compensation temperature
gets higher than the 2. point.
Influence
0
Example:
The compensation temperature limit at 2. point is set to 5 °C.
The influence is set to -2.
The actual compensation temperature (S1) is 2 degrees too high.
Result:
The desired balance / flow temperature is changed by 2 x -2 = -4
degrees.
Setting range
-9.9 ... 0 ... 9.9
Max. limitation > 0
2. point
Max. limitation < 0
32k
Factory setting
0.0
Compensation temp.
The grey
side of the
ECL Card