Setting Up How A Fault Is Triggered And How It Is Presented; Fault Status; Fault 1 Mode; Setting The Duration Of The Fault Condition - evertz 7700 Manual

7700 MultiFrame Manual
7735AVC-LB Video Composite Encoder and Audio DAC with SoftSwitch

7.7.1. Setting Up How a Fault Is Triggered and How It Is Presented

The AVC has two fault conditions that can be configured to warn the user of numerous conditions. The
Fault condition 1 and Fault condition 2 menu items are used to configure when fault 1 or fault 2 are
triggered, and how the fault should be presented. The controls for each fault condition operate the same
way, therefore for simplicity, the manual shows only the menu items for Fault condition 1.

7.7.1.1. Fault Status

Fault definitions
Fault condition 1
Fault status

7.7.1.2. Fault 1 Mode

Fault definitions
Fault condition 1
Fault 1 mode
Enable
Disable

7.7.1.3. Setting the Duration of the Fault Condition

Fault definitions
Fault condition 1
Fault duration
Until reset
1 to 254 frames
30 frames

7.7.1.4. Determining What Items Will Generate the Fault Condition

Fault definitions
Fault condition 1
7735AVC-LB - 26
This menu item displays a screen that shows the current status of all
faults that can be used to define a fault condition.
This menu item enables or disables the fault mode.
This control sets how long the fault condition will be held. The fault will
be held as long as the fault condition is active and the Fault mode is set
to Enable. The fault condition can either be held until the user clears the
condition or until a programmable timer expires.
This control provides a list of items that may generate a fault condition.
Use the toggle switch to travel up and down this list and the pushbutton
to enable or disable the item from the fault condition criteria. Enabled
items will be shown with a check mark.
A fault condition will exist when any of the selected items occur.
Revision 1.6