Selecting The Audio Groups That Will Be De-Embedded; Selecting The Audio Groups That Will Be Embedded - evertz 7700 Manual

7700 MultiFrame Manual
7711HDC HD Broadcast Quality Down Converter

6.8.1. Selecting the Audio Groups That Will Be De-Embedded

There are two controls that set the source groups for the two de-embedders. For simplicity, only one
control will be shown in the manual.
Audio
De-embedder A
Group 1
Group 2
Group 3
Group 4

6.8.2. Selecting the Audio Groups That Will Be Embedded

The model 7711HDC-SN-EAES4 has two embedders that each insert one group of audio on the SDI
output. The source for embedder A is the audio being extracted by de-embedder A. The source for
embedder B is the audio being extracted by de-embedder B. There are two controls that set the audio
groups where the embedders will put the audio on the SDI output. For simplicity, only one control will be
shown in the manual.
Audio
Embedder A
Off
Follow A
Group 1
Group 2
Group 3
Group 4
7711HDC - 28
With these controls, you can set the source group for de-embedder A and B.
Under normal conditions the settings for de-embedder A and B should be
different otherwise the audio will be repeated on the SDI output.
The default group for de-embedder A is group 1 and the default group for
de-embedder B is group 2.
With these controls, you can set the destination group for embedder A and
B.
When set to Off, the embedder will be disabled.
When set to Follow A or Follow B, the embedder destination will follow the
setting of the respective De-embedder. (See section 6.8.1)
Otherwise the embedder destination can be set to a specific group.
The group for Embedder A must be different from Embedder B. If the user
sets them the same then the next higher group number will be used for
Embedder B.
Revision 1.1