Table of Contents
Advertisement
4.8 Electrode Model Setting
This section describes the procedures to set the ion species or ion valency to be
measured.Select the ion species or ion valency to be measured.
4.8.1 Ion species Selection
4.8.2 Electrode Model Entry
HINT!
To delete a registered electrode model name, tap
name, enter nothing, and tap
60
1.
Tap
on the right of the Ion species item.
The ion species selection screen appears.
Tap
when do not reflect the setting.
2.
Select the ion species to be measured.
Tap ion species, and the selected ion species
applies.
You can set a desired electrode model name
with up to 10 characters.
1.
Tap
on the right of the Electrode model item.
2.
Enter an electrode model name using the key-
board screen.
Tap
to switch the keyboard entry screen of
Alphabet --> Numerical/Symbol. Tap
input in and lower-case alphabets.
Up to 10 characters can be input.
3.
Tap
.The setting applies.
To cancel the settings, tap
on the right of the electrode model
.
to
.
Advertisement
Table of Contents
