3.10 Electrode Model Setting
When an electrode model is set, the model name can be displayed on data printouts or
recorded in saved data.
Select the electrode model to be used for measurement.
You can set a desired name with up to 10 characters by selecting the Customize item.
3.10.1 Electrode Model Selection
3.10.2 Electrode Model Entry
HINT!
To delete a registered electrode model name, tap
name, enter nothing, and tap
48
1.
Tap
on the right of the Electrode model item.
The electrode model selection screen appears.
Tap
when do not reflect the setting.
2.
Select the electrode model to be used.
Tap an electrode model name, and the selected
model applies.
You can set a desired name with up to 10
characters.
1.
Tap "Customize" in the electrode model selection
screen.
2.
When selecting Customize for the Electrode
model item, the Customize item is displayed.
Tap
on the right of the Customize item.
3.
Enter an electrode model name using the key-
board screen.
Tap
to switch the keyboard entry screen of
Alphabet --> Numerical/Symbol. Tap
input in lower-case alphabets.
Up to 10 characters can be input.
4.
Tap
.
The setting applies.
To cancel the settings, tap
on the right of the electrode model
.
to
.