Table of Contents
Advertisement
9.5 Cal. results_All
All calibration data, including the ones not used actually because of an error during
calibration, are displayed on this screen.
9.6 Copy all meas. Data
Before copying data, make sure that sufficient capacity is available in the USB memory.
If the copy stops in the middle, turn OFF the power and reboot the instrument, and then
execute the copy again.
You can check the latest 20 data of pH and ION
calibration.
The data are sorted in descending order of
calibration data.
1.
Tap
on the right of the Cal. results_All.
2.
Tap
on the right of each measured item.
3.
Tap
on the right of the data to be checked.
4.
After the check is completed, tap
return the Cal. Result_All screen.
You can save the copy of the measurement data
saved in the instrument into a USB memory. To
execute the copy, connect a USB memory to the
instrument.
1.
Tap
on the right of the Copy all meas. Data.
2.
Tap
to execute the all measurement data
copying. Not to execute, tap
3.
Tap
in the Copy all meas. Data completion
screen.
to
.
93
Advertisement
Table of Contents
