Connecting The Power Source; Connecting The Printer - Horiba Scientific LAQUA F-73A-S Instruction Manual

1.7 Connecting the Power Source

AC adapter connector

1.8 Connecting the Printer

Printer connector
The following printer is available.
Printer
CITIZEN CBM-910-24RJ120 V: plain paper type (Parts No.: 3014030146)
CITIZEN CBM-910-24RJ230 V: plain paper type (Parts No.: 3014030147)
Optional printer cable (Parts No.: 3014030148) is required.
・ Make sure to use the appropriate cable for the printer.
・ Make sure to power OFF the instrument before connecting a printer.
・ When you do not connect a printer with the instrument, disconnect the printer cable and
put the rubber cap firmly on the connector socket on the instrument.
● Setting the Printer
Refer to the instruction manual of the printer for settings and operations of the printer.
1. Set the DIP switch No. 6 to ON and No. 7 to OFF, and then set printer paper and ink
ribbon. Keep the LF key held down.
2. Keep the SEL key held down.
The printer prints output when the SEL key is being pressed.
14
1.
Insert the AC adapter cable by fitting
with the connector socket of in the
instrument.
Do not insert the cable with force when
the connectors do not match.
1.
Insert the printer cable by fitting with the
connector socket of in the instrument.
Do not insert the cable with force when
the connectors do not match.