Advertisement
D/A Output
See: Instruction Manual "8 D/A Output"
Before connecting a device to the D/A output
„
terminal, turn off the main power switches
on the instrument and the device being
connected, and disconnect the measurement
leads from the measurement target.
Failure to do so could cause the operator to
experience an electric shock or damage the device.
External Control (EXT. I/O)
See: Instruction Manual "9 External Control (EXT. I/O)"
Do not apply voltage (current) to the EXT. I/O
„
connector that exceeds the maximum input
voltage (current).
Doing so could cause damage to the instrument,
resulting in serious bodily injury.
Do not supply external power to the
„
instrument's EXT. I/O connector.
External power cannot be supplied to the instrument's
EXT. I/O connector. The ISO_5V pin of the EXT. I/O
connector is a 5 V (NPN)/ −5 V (PNP) power output
terminal. Doing so could damage the product.
When connecting a device to the instrument's
„
EXT. I/O connector, use screws to secure the
connector.
During operation, a connector becoming dislocated
and contacting another conductive object could cause
an electric shock.
Follow the steps below before wiring the
„
EXT. I/O connector.
1. Turn off the instrument and the device being
connected.
2. Remove any static electricity charged on your body.
3. Confirm that the signals do not exceed the rating
for the external I/O.
4. Properly isolate the instrument and the device
being connected.
Communications functionality
See: Instruction Manual "10 Communications (USB/RS-232C/
LAN Interface)"
Turn off all devices before connecting or
„
disconnecting interface connectors.
Failure to do so could cause the operator to
experience an electric shock.
WARNING
DANGER
WARNING
WARNING
HIOKI RM3545E965-00
Removing the lithium battery
See: Instruction Manual "13.4 Disposing of the Instrument"
Before removing the lithium battery, turn
„
off the instrument's main power switch and
disconnect the cords and leads from the
measurement target.
Failure to do so could cause the operator to
experience an electric shock.
Store the removed lithium battery out of
„
reach of children.
Failure to do so could allow children to accidentally
ingest battery.
Rack Mounting
See: Instruction Manual "14.18 Rack Mounting"
When installing the rack mounting plate on
„
the sides or the bottom, do not allow the
screws to intrude more than 3.5 mm inside
the instrument.
Doing so could damage the instrument, causing the
operator to experience an electric shock.
When installing the rack mounting plate on
„
the instrument, use the specified screws.
×
(M4
8 mm)
When removing the rack mounting plate to
„
return the instrument to standalone use,
reuse the same screws that were installed
originally.
×
(Feet: M3
6 mm, sides: M4
Fixing with other screws could cause damage to the
instrument, resulting in bodily injury. If you lose or
damage the screws, contact your authorized Hioki
distributor or reseller.
6
WARNING
WARNING
×
6 mm)
Advertisement
