Hioki RM2611 Instruction Manual

RM2611
ELECTRODE RESISTANCE METER
Instruction Manual
Revised edition
Feb. 2020
RM2611A961-01 20-02H
1
1
Introduction
Thank you for choosing the Hioki RM2611 Electrode
Resistance Meter. Preserve this manual carefully and keep
it handy to make full use of this instrument for a long time.
Familiarize yourself with the RM2610 Electrode Resistance
Measurement System Instruction Manual and the separate
document entitled "Operating Precautions" before using the
product.
Target audience
EN
This instruction manual has been written for use by individuals
who use the product or provide information about how to use
the product. In explaining how to use the product, it assumes
electrical knowledge (equivalent of the knowledge possessed
by a graduate of an electrical program at a technical high
school).
Safety notations
This manual classifies seriousness of risks and hazard levels
as described below.
Indicates action that must be performed.
Inspection
Conduct an inspection and check instrument operation to
ensure that no damage has occurred during storage or
transport.
Troubleshooting
If damage is suspected, review the suggestions described
under "Before having your product repaired" section of
the RM2610 Electrode Resistance Measurement System's
instruction manual before contacting your authorized Hioki
distributor or reseller.
Cleaning
If the instrument becomes dirty, slightly moisten a soft cloth
with water or a neutral detergent and wipe it clean.
Operating Precautions
Observe the following precautionary information to ensure
that the product can be used safely and in a manner that
allows it to perform as described in its specifications.
Do not place the product on an unstable or uneven
surface. Doing so could cause the product to fall or turn
over, causing bodily injury or damage to the product.
CAUTION
2