Front Panel Description - MAGSTIM 200 2 Operating Manual

2
Magstim 200
SECTION 3:
NOTE
ON/OFF (Standby) Button (1)
The Magstim Company Limited 3001-23-04

FRONT PANEL DESCRIPTION

1. All operating functions described in this section assume that the
mains power switch, located on the rear panel, is in the ON position.
2. For the Magstim 200
control unit shown in the above diagram, functions 4 to 17 are
implemented on the remote control coils. For details of the remote
control coils see Magstim Remote Control Coils Operating Manual –
3179-23.
This switch toggles the operational state of the Magstim 200
application of mains power, the Magstim 200
This is indicated by the Power State indicator (3) flashing. Pushing the
ON/OFF switch when the unit is in its Standby state will set the
2
Magstim 200 into its operational state. This is indicated by the Power
State indicator (3) being continuously illuminated. All LEDs and symbols
will illuminate within a period of 5 seconds. At the end of 5 seconds the
OUTPUT % DISPLAY will default to 30%, and the inactive default
condition indicator (10) will illuminate. At the end of the session the
2
Magstim 200 can be returned to its Standby condition by pushing the
ON/OFF switch.
2
- 3006-00, which is supplied without the
2
5
2
. On initial
enters its Standby state.
LUMENIS EX1091
th
18 March 2005
Page 7