Specifications; General Specifications - MAGSTIM 200 2 Operating Manual

2
Magstim 200
SECTION 10: SPECIFICATIONS

GENERAL SPECIFICATIONS

This equipment is classified as Class 1, with type BF Applied Parts.
The system complies with the requirements of the Safety Standard EN60601-1
(90), including amendment 1 (91) and amendment 2 (95) and EMC Standard
EN 60601-1-2.
Protection against ingress of liquids - The Magstim 200
are classified as IPXO (Not Protected), as there is no specialised protection
provided against the ingress of liquids.
Protection against flammable anaesthetic mixtures – Not Protected.
Therefore, the Magstim 200
presence of a flammable anaesthetic mixture with air, oxygen or nitrous oxide.
Mode of Operation – Continuous
EMC General
The Magstim 200
equipment and that if adjacent or stacked use is necessary, the equipment
should be observed to verify normal operation in the configuration in which it
will be used.
EMC Susceptibility
The Magstim 200
installed and put into service according to the EMC information provided in
Section 11 of this Operating Manual. To avoid interference problems the
Magstim 200
equipment that does not comply with EMC Standard EN 60601-1-2, including
portable and mobile RF communications equipment, such as mobile phones.
EMC Emissions
The use of accessories, transducers and cables other than those specified by the
Magstim Company Ltd., may result in increased emissions, or decreased
immunity, of the equipment. In order to ensure EMC compliance, the Magstim
2
200
Ltd. for use with the Magstim 200
The Magstim Company Limited 3001-23-04
2
should not be used adjacent to, or stacked with, other
2
needs special precautions regarding EMC and needs to be
2
, and its accessories, should not be used in the vicinity of any
must be used only with those parts specified by the Magstim Company
2
and its accessories are not suitable for use in the
2
.
26
2
and its accessories
LUMENIS EX1091
Page 28
th
18 March 2005