Table of Contents
Advertisement
2
Magstim 200
COIL
Please note: it is important that the coil is connected correctly. If the coil
appears to be misaligned, remove and re-connect the coil. Do not use if the
coil appears misaligned.
4. Set the MAINS POWER switch on the rear of the unit to the ON (I)
position. The Unit Power Status Indicator LED will flash at approximately
0.5Hz, indicating that the unit is in a standby condition.
5. Push the ON/OFF button on the front panel of the unit. The Unit Power
Status Indicator LED will be continuously lit, indicating that the unit is
operational and is in its safe inactive default condition.
6. All LEDs and symbols will illuminate within a period of 5 seconds. At
the end of the 5 second period, the OUTPUT % DISPLAY will indicate
an output power level of 30%, and the DEFAULT CONDITION indicator
will remain illuminated.
7. Ensure that all indicator LEDs are functioning properly before
proceeding; if not, contact The Magstim Company Service Department.
The Magstim Company Limited 3001-23-04
13
LUMENIS EX1091
Page 15
th
18
March 2005
Advertisement
Table of Contents
