Product Descriptions; Front Panel - MAGSTIM BiStim2 Operating Manual

SECTION 3 PRODUCT DESCRIPTIONS

Front Panel

3.1
The front panel, shown below, allows control of the Magstim Bistim² and provides the connection for
the stimulating coil.
Note: UI functions described in this section are to be performed on the master unit UI (Bistim² UI).
Control functions/buttons are not activated on the slave unit UI (200² UI) therefore cannot be used to
control system. The only function/button that may be used is the system stop button.
15
The upper unit is considered the master unit. The lower unit is considered the slave unit.
All operating functions described in this section assume that the mains power switches, located on
the rear panel of the master and slave units, are switched on.
3.1.1
The on/off button toggles the master and slave units of the Magstim Bistim² between on and standby.
3.1.2
The armed indicator illuminates when the unit is armed allowing it to be triggered.
© The Magstim Company Limited
1 2
On/Off Button* (1)
Armed Indicator* (2) & (9)
3
Master
Slave
Figure 3.1: Detailed front panel
5
Magstim BiStim²
Operating Manual
4 5 6 7
MOP02-EN-02
8
9
10
11
13
12
14