Preparations For Use - MAGSTIM 200 2 Operating Manual

2
Magstim 200
SECTION 5: PREPARATIONS FOR USE
IMPORTANT
To avoid interference problems the Magstim 200
should not be used in the vicinity of any equipment that does not comply
with EMC Standard EN 60601-1-2.
Before using the instrument, ensure that the correct fuses are fitted and that
the voltage selector is set to suit the supply voltage (see Section 9). Check
the Magstim 200
Magstim 200
not be used.
If a number of Magstim 200
part of a BiStim system, it may be desirable for the units to be stacked on
top of each other. The Magstim 200
the units may be safely stacked on top of each other. The maximum
number of units that can be safely stacked on top of the base Magstim
200
base Magstim 200
and overbalance, causing injury to the patient, or user, and damage to the
Magstim units.
1. Insert the pneumatic connector of the foot switch to the rear panel
FOOTSWITCH socket on the Magstim 200
2. If a recording device is being used, synchronise the Magstim with the
recording instrument by following the instructions in Section 4 –
ISOLATED TRIGGER I/O Port.
3. Ensure that the locating spot on the coil plug is correctly lined up with
the COIL OUTPUT SOCKET, located on the front panel of the Magstim
200
When the coil plug is fully engaged in the socket, lock the plug in place by
turning the black locking ring clockwise until it clicks into place.
The Magstim Company Limited 3001-23-04
2
and its accessories for any signs of damage. If the
2
, or any of its accessories, are damaged in any way they must
2
is 3. Attempts to exceed this limit could result in crush damage to the
2
. In addition, the stacked units could become unstable
2
. Insert the connector of the stimulating coil into the output socket.
2
units are being used, or the Magstim 200
2
enclosure has been designed such that
2
.
12
2
, and its accessories,
2
LUMENIS EX1091
th
18 March 2005
is
Page 14