Table of Contents
Advertisement
2
Magstim 200
SECTION 4:
MAINS POWER Switch (1)
ISOLATED INTERFACE (RS232/ trigger) Port (2)
WARNING
Pin Connections (26D)
The Magstim Company Limited 3001-23-04
REAR PANEL DESCRIPTION
To connect the mains supply to the Magstim 200
switch the ON (I) position. To disconnect the mains supply, the mains
switch on the rear panel of the unit must be set to the OFF (0) position.
(Only equipment complying with EN 60601-1, and configured in compliance
with EN 60601-1-1, should be connected to this interface port)
(Unless otherwise indicated, signal levels are 5V CMOS Logic)
1. Aux GND
2. *
3. Tout – O/C
4.*
5. +ve Trigger In
6. -ve Trigger In
7. +ve Trigger Out 16. *
8. -ve Trigger Out
9. *
Factory Use Only – DO NOT CONNECT
*
†
No Connection – Edge Trigger
Connect Pin 24 to Pin 19 – LEVEL Trigger
10. Aux. +5V
11. Aux. GND
12. Rx (RS232 Level) 21. *
13. Tx (RS232 Level) 22. *
14. *
15. *
17. *
18. *
10
2
set the mains power
19. Aux GND
20. *
23. *
24. †Trigger Edge/ Level
25. *
26. *
LUMENIS EX1091
Page 12
th
18
March 2005
Advertisement
Table of Contents
