Product Descriptions; Front Panel - MAGSTIM 2002 Operating Manual

Magstim 200
2
Operating Manual
SECTION 3 PRODUCT DESCRIPTIONS
3.1 Front Panel
The front panel, shown below, allows control of the Magstim 200
2
and provides the connection for the
stimulating coil.
If a Magstim 200
2
UI Controller is not used, functions 4 to 14 are implemented on the Remote Control
Coils and details can be found in appropriate remote control coil operating manual.
•
I ••••••
L
Figure 3.1: Front panel
8
-
..
All operating functions described in this section assume that the mains power switch, located on the
rear panel, is switched on.
3.1.1
On/Off Button (1)
(!)
The on/off button switch toggles the Magstim 200
2
between on and standby.
®
3.1.2
Armed Indicator (2) & (9)
The armed indicator illuminates when the unit is armed allowing it to be triggered.
3.1.3
Power Indicator (3)
The power indicator flashes when the Magstim 200 2 is in standby, and illuminates when the Magstim
200
2
is on. When power is initially applied to the Magstim 200
2
,
the power indicator should flash
indicating the unit is in standby state.
© The Magstim Company Limited 4 MOP01-EN-01