Table of Contents
Advertisement
Kollmorgen
Package
5
5.1
Package supplied
When you order a SERVOSTAR 600 series amplifier (order numbers ð p.117), you will receive:
—
—
The mating SubD connectors and motor connector X9 are not part of the package!
—
—
—
Accessories: (must be ordered separately; description see accessories manual)
—
—
—
—
—
—
—
—
—
5.2
Nameplate
The nameplate depicted below is attached to the side of the servo amplifier.
The information described below is printed in the individual fields.
Servo amplifier type
®
SERVOSTAR
601...620 Instructions Manual
SERVOSTAR 6xx
mating connectors X3, X4, X0A, X0B, X7, X8
Assembly, Installation and Setup Instructions (Instructions Manual)
Online documentation on CD-ROM
Setup software DRIVE.EXE on CD-ROM
AC synchronous servomotor (linear or rotary)
motor cable (pre-assembled), or both motor connectors separately, with motor cable as a
cut-off length
feedback cable (pre-assembled or both feedback connectors separately,
with feedback cable as length
Power supply for encoders with a power consumption of more than 150mA (ð p. 113)
Terminating adapter for encoders with no terminating resistors (ð p. 113)
motor choke 3YL for cable length above 25m
external brake resistor BAR(U)
communications cable to the PC(ð p.69) or Y-adapter (ð p.84) for setting parameters of up
to 6 servo amplifiers from one PC
power cable, control cables, fieldbus cables (as lengths)
max. ambient
temperature
07/2010
Serial number
Electrical supply
Installed load
Comments
Enclosure Rating
Output current
Hardware Revision
in S1 operation
Package
19
Advertisement
Table of Contents
