Table of Contents
Advertisement
Setup
9.3.6
Feedback
80
07/2010
Press F12 (disable) before changing feed-
back parameters.
Feedback Type:
Select the feedback type used.
Leave all other fields unchanged.
If Software Enable is active, a warning appears.
The configuration change cannot be performed.
Click OK on the warnings, press F12 (SW dis-
able) and start the Feedback procedure again.
If everything was ok, the same procedure (pa-
rameter upload) that has been described for the
motor selection starts.
If you click "Yes", the parameters are saved in
the EEPROM and the amplifier makes a
coldstart (reset). This takes some seconds.
®
SERVOSTAR
601...620 Instructions Manual
Kollmorgen
Advertisement
Table of Contents
