Configuring The "Door Alarm" Function - Busch-Jaeger Busch-Welcome IP Product Manual

8.5.4

Configuring the "Door alarm" function

Please follow the steps below:
[1] On the "Outdoor Stations" screen, go to the "Door Alarm" section.
[2] Tick the check box to enable the functions.
If the "Detection Alarm" function is enabled, the panel will send an alarm to SmartAP when
■
the door is open for longer than 120 s (a sensor should first be connected to the outdoor
station).
If the "Local Alarm" function is enabled, the panel also sounds an alarm locally.
■
If the "Tamper proof Alarm" is enabled, the panel will send an alarm to SmartAP if the
■
Outdoor Station is removed from the wall.
[3] Tap "X Settings" to exit the setting.
[4] Tap "OK" to save the change.
Product manual 2TMD042300D0041
Commissioning
│144