Configuring The Outdoor Station; Accessing The "Outoodr Stations" Screen - Busch-Jaeger Busch-Welcome IP Product Manual

8.5

Configuring the Outdoor Station

8.5.1

Accessing the "Outoodr Stations" screen

This chapter applies to the mini Outdoor Station and pushbutton Outdoor Station.
Entering engineering mode
Please follow the steps below:
[1] Power on the Outdoor Station, wait until all 3 LED indicators go out.
[2] Press and hold the first pushbutton for the designated time until all 3 LED indicators flash.
For the mini Outdoor Station, the designated time = 5 seconds
■
For the pushbutton Outdoor Station, the designated time = 10 seconds
■
Accessing the "Outdoor Stations" screen
The following operations use the pushbutton Outdoor Station as an example.
Please follow the steps below:
[1] Ensure that the Outdoor Station is in engineering mode.
[2] On the "Settings" screen of the panel, tap "Advanced settings".
[3] Tap "Outdoor Stations" to access the corresponding screen.
Note
The Outdoor Station will exit engineering mode if no operation is carried out for 5
minutes.
Product manual 2TMD042300D0041
Commissioning
│134