Configuring The "Report When Unlock" Function - Busch-Jaeger Busch-Welcome IP Product Manual

8.4.4

Configuring the "Report when unlock" function

If this function is enabled, each unlock record from the IP Actuator will be sent to SmartAP.
Please follow the steps below:
[1] On the "Actuators" screen, go to the "Lock management" section.
[2] Tick the check box to enable the function.
[3] Tap "X Settings" to exit the setting.
[4] Tap "OK" to save the change.
Product manual 2TMD042300D0041
Commissioning
│130