8.4.6
Configuring the "Door status detection" function
If this function is enabled, when the door is open longer than the setting value, the IP actuator
will send an alarm to the SmartAP (a sensor should first be connected to the IP actuator).
Please follow the steps below:
[1] On the "Actuators" screen, go to the "Door status" section.
[2] Tick the check box to enable the function.
[3] Enter the door open period (60 seconds default).
[4] Tap "X Settings" to exit the setting.
[5] Tap "OK" to save the change.
Product manual 2TMD042300D0041
Commissioning
│132