Table of Contents
Advertisement
3 BASIC OPERATIONS
3.5 Changing the Channel
Operating the Transceiver
Using the [ ]/ [ ] key or the [<B] or [C>] key
1
Press the
Channel Entry
The transceiver enters Channel Entry Mode.
If the maximum channel number is a two-digit number, "_ _." appears on the LED display and the dot on the right side blinks.
If the maximum channel number is a single-digit number, "_." appears on the LED display and the dot on the right side blinks.
2
Select a channel number by pressing the
Note
• The transceiver behavior when a channel is selected varies according to the configurations for Voice Announcement and
Zone Type. (Refer to
• If no key is pressed before the amount of time configured for Mode Reset Timer elapses, the transceiver exits Channel Entry
Mode. If a channel number has been selected, the transceiver migrates to the selected channel.
3
Press the [S], [A], or
The transceiver exits Channel Entry Mode and then migrates to the channel of the number entered.
Using the Microphone Keypad
1
Press the
Channel Entry
The transceiver enters Channel Entry Mode.
If the maximum channel number is a two-digit number, "_ _." appears on the LED display and the dot on the right side blinks.
If the maximum channel number is a single-digit number, "_." appears on the LED display and the dot on the right side blinks.
Note
The following operations are identical even if the transceiver enters Channel Entry Mode with microphone keypad entry
(Keypad Operation).
2
Enter a channel number by pressing the
A channel number can be entered as follows:
• If the maximum channel number has 2 digits:
To make a call on channel 10, press the [1] and [0] keys in this order.
To make a call on channel 7, press the [0] and [7] keys in this order or [7] and [*] keys in this order.
• If the maximum channel number has 1 digit:
To make a call on channel 7, press the [7] key.
If a channel number is entered, the transceiver exits Channel Entry Mode and then migrates to the channel of the number
entered.
Note
• If an unprogrammed channel number is entered, an Error Tone sounds from the transceiver and the transceiver exits
Channel Entry Mode.
• Pressing the [#] or [A] key deletes the entered number if the maximum channel number has 2 digits. The transceiver exits
Channel Entry Mode by pressing the [*] or [A] key while no number is entered.
• If no key is pressed before the amount of time configured for Mode Reset Timer elapses while the transceiver is in Channel
Entry Mode, the transceiver exits Channel Entry Mode.
Configuration using KPG-175D
•
Assigning functions to the PF keys (
•
Configuring the Keypad Operation (
FUNC (K)/Ver 1.20
key.
[
3.6 Transceiver Behavior When the Zone-channel Is Changed on page
Triangle
key.
key.
[0]
to
Edit > Key Assignment)
See
Edit > Key Assignment > Microphone Key)
See
]
or
[
]
key or the
[<B]
or
[9]
keys on the microphone keypad.
[C>]
key.
14.)
CONTENTS
INDEX
13
Advertisement
Table of Contents
