Table of Contents
Advertisement
10 FleetSync
10.4 Making a Selective Call/ Paging Call
Selective Call Alert LED
Selective Call Alert LED is the function to make the LED blink orange or blue when the transceiver receives a call.
A user can notice by the LED that the transceiver is receiving a call.
Note
The color of the blinking LED can be configured by types of calls by using KPG-169D/ KPG-170D/ KPG-175D.
Configuration using KPG-169D/ KPG-170D/ KPG-175D
•
Configuring the Selective Call Alert LED (
•
Configuring the LED (Individual Call/Group Call) (
•
Configuring the LED (Other Selective Calls) (
Restricting IDs for Which the Talkback Is Available (Unit ID Encode Block)
Unit ID Encode Block is the FleetSync ID range that the transceiver can respond (Talkback).
FleetSync IDs to which a user is allowed to respond (Talkback) can be restricted using KPG-169D/ KPG-170D/
KPG-175D.
The transceiver unmutes the speaker and emits received audio when the transceiver receives the FleetSync ID satisfying
the receiving conditions. The receiving transceiver can respond (Talkback) to the transmitting transceiver by a user
pressing the PTT switch. However, the transceiver cannot respond (Talkback) if the transceiver is inhibited to respond
(Talkback) to the FleetSync ID of the transmitting transceiver.
Note
• The transceiver can respond (Talkback) to a FleetSync ID configured in the ID List even if it is outside the Unit ID Encode Block range.
• The transceiver for which Unit ID Encode Block is not configured can respond (Talkback) to all transceivers.
Configuration using KPG-169D/ KPG-170D/ KPG-175D
Configuring the Unit ID Encode Block (
Auto Reset Timer
Auto Reset Timer counts down the amount of time from when the received FleetSync ID matches the FleetSync ID (Own)
preconfigured for the transceiver until the matching status is automatically reset. The matching state means that a user
can communicate only using QT tone or DQT code after the FleetSync ID is matched.
Auto Reset Timer can be configured by using KPG-169D/ KPG-170D/ KPG-175D.
Configuration
Off
Auto Reset Timer will not be activated.
After the time configured for Auto Reset Timer elapses, the matching state of the FleetSync ID is automatically
1 s to 300 s
reset.
Note
• For Portable, Auto Reset Timer is canceled if the channel is changed or any PF key is used while the Auto Reset Timer is counting
down. The Alert Tone stops sounding and the blinking LED is turned Off at this time.
• For Mobile, Auto Reset Time is canceled if any PF key other than the Emergency, Volume Up, Volume Down, and LED Brightness
key is used while the Auto Reset Timer is counting down. The Alert Tone stops sounding and the blinking LED is turned Off at this time.
FUNC (K)/Ver 1.20
Edit > FleetSync > General 2 > LED)
See
Edit > FleetSync > General 2 > LED)
See
Edit > FleetSync > General 2 > LED)
See
Edit > FleetSync > General 1)
See
Table 10-7 Auto Reset Timer
Description
CONTENTS
INDEX
114
Advertisement
Table of Contents
