Kenwood NX-240 Function Reference page 110

8 NXDN CONVENTIONAL SYSTEM
8.11 Disabling the Transceiver Capability by Remote Control (Stun/ Kill)
GPS Functions
The following functions are relevant to GPS data transmission:
• Number of Times
• GPS Report Interval Time
• GPS Time Mark
• GPS Message Type
• GPS Report on Data Zone-Channel
• GPS Report Back to Requested ID
Refer to 13 GPS FUNCTIONS on page 145
8.11 Disabling the Transceiver Capability by Remote Control
(Stun/ Kill)
This is the function that is used to disable the transceiver capability by remote control. This function allows a system
administrator to remotely disable the transceiver, for instance, if the transceiver is lost.
The transceiver which has been disabled by this function can be enabled to be usable again by remote control from an
external device using radio communication.
The transceiver behaves as follows according to the type of a message when a Remote Control Message is received.
Remote Control
Message
The transceiver is disabled if the transceiver receives the Remote Stun Message.
Whether to accept the Remote Stun Message upon the reception can be configured using KPG-169D/
Remote Stun
KPG-170D/ KPG-175D.
If the transceiver receives the Remote Revive Message, the Stun state will be reset.
Remote Revive If the transceiver receives the Remote Revive Message, the Stun state will be reset.
If the transceiver receives the Remote Kill Message, the transceiver is disabled and all operations will be
prohibited. All configuration data of the transceiver is cleared; hence Stun state will not be reset even if the
transceiver receives the Remote Revive Message. However, the configuration data can be written to the
Remote Kill
transceiver using KPG-169D/ KPG-170D/ KPG-175D.
Whether to accept the Remote Kill Message upon the reception can be configured using KPG-169D/
KPG-170D/ KPG-175D.
Note
• NX-240/ 240V/ 340/ 340U/ 740H/ 740HV/ 840H/ 840HU can receive the Remote Control Message; however, it cannot send the
Remote Control Message.
• GPS data is automatically sent while the transceiver is in Stun state.
• The transceiver cannot be placed in Emergency Mode while the transceiver is in Stun state.
• The LED cannot light or blink while the transceiver is in Stun state.
Configuration using KPG-169D/ KPG-170D/ KPG-175D
Configuring the Remote Stun/Kill to be enabled or disabled (
FUNC (K)/Ver 1.20
for details of each function.
Table 8-11 Remote Control
Description
See Edit > NXDN > General 1)
CONTENTS INDEX 85