Table of Contents
Advertisement
14
COMMUNICATIONS IN AN EMERGENCY
Emergency is the function to be used for the transceiver to transmit and receive for emergency purposes. This function is
used for a user to immediately contact the base station in emergency situations.
The transceiver behaves according to the configurations in Emergency Mode when the transceiver is placed in Emergency
Mode. The base station transceiver can notice an occurrence of an emergency situation in the transmitting transceiver
upon receipt of a call by use of Emergency.
Portable
For Portable, pressing and holding the Emergency key for longer than the time configured for Hold Delay causes the
transceiver to enter Emergency Mode. (Refer to
"Emergency" can be assigned for the Side 1 key or Side 2 key only as the function when the key is held.
The following figure shows a configuration example when "Emergency" is assigned for Hold of the Side 1 key by using
KPG-169D/ KPG-170D. In this case, the transceiver enters Emergency Mode if the Side 1 key is pressed and held for
2 sec or more.
Mobile
For Mobile, pressing and holding the Emergency key for longer than the time configured for Emergency-key Delay
Time causes the transceiver to enter Emergency Mode. (Refer to
page
151.)
"Emergency" can be assigned for the Triangle key only as the function when the key is held.
The following figure shows a configuration example when "Emergency" is assigned for Hold of the Triangle key by
using KPG-175D. In this case, the transceiver enters Emergency Mode if the Triangle key is pressed and held for 2
sec or more. For Mobile, the value of Hold Delay varies according to the configuration for Emergency-key Delay Time.
If the Lone Worker function is enabled, the transceiver enters Emergency Mode when the time configured for Lone Worker
Interval elapses in Lone Worker Mode and then the time configured for Duration of Lone Worker Tone elapses. The Lone
Worker Tone sounds from the transceiver for the time configured for Duration of Lone Worker Tone. (Refer to
the Transceiver in Emergency Mode Using Lone Worker on page
FUNC (K)/Ver 1.20
14.1 Placing the transceiver in Emergency Mode on page
Figure 14-1 Configuration Example using KPG-169D/ KPG-170D
Figure 14-2 Configuration Example using KPG-175D
14.1 Placing the transceiver in Emergency Mode on
161.)
CONTENTS
151.)
14.6 Placing
INDEX
149
Advertisement
Table of Contents
