Kenwood NX-240 Function Reference page 210

18 FUNCTION PORTS
18.2 Available Functions for AUX Output Ports
18.2 Available Functions for AUX Output Ports
The following functions can be assigned to AUX Output ports:
Function Name
None No function is assigned.
The output port goes low level while the transceiver is receiving a carrier. Otherwise, the output port goes
COR
high level.
The output port goes low level while the received QT tone, DQT code (Analog), or RAN code (NXDN)
matches the QT tone, DQT code (Analog), or RAN code (NXDN) preconfigured for the transceiver. If QT/
TOR DQT Decode is not configured, the output port goes low level while the transceiver is receiving a carrier. If
RAN Decode is not configured, the output port goes low level while the transceiver is receiving a RAN code.
Otherwise, the output port goes high level.
The port output is changed with the state of the AUX key. An external device connected to the AUX port can
AUX
be controlled.
PTT Output The output port goes low level while the PTT switch is being pressed. Otherwise, this port goes high level.
TXS The output port goes low level while the transceiver is transmitting. Otherwise, this port goes high level.
The status of the port is changed when the transceiver receives a FleetSync or NXDN Status Message. The
status of the port is toggled (High to Low or Low to High) when the received Status Message matches the
Status number preconfigured for the port.
Two statuses (High  Low, Low  High) can be configured for AUX Output Status Message by using
AUX Output Status
KPG-175D. The port is usually used to remotely control the transceiver by connecting an external device to
Message
the AUX Output port. (Refer to
page
Also, the port status can be retained even if the transceiver is turned OFF. (Refer to
(AUX Output Status Message) on page
Configuration using KPG-175D
Assigning functions to the AUX Output port (
FUNC (K)/Ver 1.20
Table 18-2 Available Functions for AUX Output Ports
AUX Output Status Message on page
120)
Edit > Extended Function > AUX)
See
Description
74,
186.)
CONTENTS
AUX Output Status Message on
18.3 Status Memory
INDEX 185