Kenwood NX-240 Function Reference page 106

8 NXDN CONVENTIONAL SYSTEM
8.9 Site Roaming
Off-hook Site Roaming
Supported Models: Mobile
Off-hook Site Roaming is the function to start the Site Roaming depending on the status of microphone, either on-hook or
off-hook.
The transceiver behaves as follows according to the configuration for Off-hook Site Roaming.
Configuration
The transceiver can start Site Roaming while the microphone is in either the on-hook state or off-hook state.
Enabled Even if the microphone changes from the On-hook state to Off-hook state during Site Roaming, Site Roaming
will not pause.
The transceiver can start Site Roaming if the microphone is in the on-hook state. The transceiver cannot start
Site Roaming if the microphone is in the off-hook state.
If the microphone changes from the On-hook state to Off-hook state during Site Roaming, Site Roaming will
Disabled
temporarily pause on the Revert Channel. Even if the microphone changes from the On-hook state to Off-hook
state while Site Roaming pauses, the channel will not be changed. When the microphone goes to On-hook state,
the transceiver resumes Site Roaming.
Note
The microphone hook status can be switched on the AUX Input port to which "External Hook" is assigned. (Refer to
Functions for AUX Input Ports on page
Configuration using KPG-175D
Configuring the Off-hook Site Roaming to be enabled or disabled (
Site Roaming (NXDN))
FUNC (K)/Ver 1.20
Table 8-10 Off-hook Site Roaming
182.)
Description
Edit > Scan Information >
See
CONTENTS
18.1 Available
INDEX 81