Table of Contents
Advertisement
A APPENDIX
A.1 Available Functions for the PF Keys
Mobile
The following functions can be assigned to the PF keys of the transceiver using KPG-175D:
Function Name
None
Nothing will be activated.
The DTMF code corresponding to the list number in the Autodial List configured for the
Autodial
selected channel is sent.
Refer to
12.1 Sending a DTMF Code Using the Autodial Key (Autodial) on page
The status of the AUX Output port is alternated. The AUX A Output port status is changed
to inactive if the status is active; or, the AUX A Output port status is changed to active if
the status is inactive. Status of the AUX port can be changed by pressing the AUX key,
hence an external device connected to the AUX port can be controlled.
AUX
Note
The transceiver can be configured to light the 2 dots on the LED display (the left dot
and the right dot) and the LED (blue) when the AUX Output port becomes active.
(Refer to
A 2-tone code, FleetSync status, or NXDN status assigned to the Call 1 key or Call 2 key
is sent. In addition, an Individual Call (Individual Call Acknowledge Request) can be
initiated to the NXDN Unit ID assigned to the Call 1 key or Call 2.
Refer to
8.4 Initiating an Individual Call After Ensuring That the Target Party Is Available
Call 1, Call 2
for Communications (Individual Call Acknowledge Request) on page
Refer to
8.7 Sending a Status Message (Status Call) on page
Refer to
9.4 Using 2-tone to Initiate a Selective Call on page
Refer to
10.6 Sending a Status Message (Status Call) on page
Channel Down
The channel number decreases in steps of 1.
Channel Down
Pressing and holding the Channel Down (Continuous) key will decrease the channel
(Continuous)
number in steps of 1 every 200 ms.
Channel Up
The channel number increases in steps of 1.
Channel Up
Pressing and holding the Channel Up (Continuous) key will increase the channel
(Continuous)
number in steps of 1 every 200 ms.
A channel number can be directly specified using the microphone keypad.
Channel Entry
Refer to
Changing the Channel by Specifying the Number (Channel Entry) on page
A CW Message is sent.
CW Message
Refer to
8.8 Communicating using a CW Message on page
The transceiver migrates to the lowest number channel in the lowest number zone.
Direct Zone-
Refer to
Changing the Zone-channel with a Single Touch (Direct Zone-Channel) on page
Channel
14.
The transceiver enters Emergency Mode.
Note
Emergency
"Emergency" can be assigned to the Triangle key only as the function when the key is
held.
Refer to
14.1 Placing the transceiver in Emergency Mode on page
A user can toggle the speaker to be used between the external speaker connected to the
External
transceiver and the internal speaker of the transceiver.
Speaker
Refer to
6.9 Switching the Internal/ External Speaker (External Speaker) on page
FUNC (K)/Ver 1.20
Table A-2 Available Functions for the PF Keys
Description
5.5 Lighting the LEDs According to the Transceiver's Status on page
133.
25.)
61.
72.
100.
118.
12.
75.
151.
40.
CONTENTS
*1
Available System
ALL
Analog Conventional
system
ALL
ALL
ALL
ALL
ALL
ALL
ALL
NXDN Conventional
system
ALL
ALL
INDEX
199
Advertisement
Table of Contents
