Danfoss VLT FC 102 Operating Manual page 95

VLT HVAC Drive FC 102
Operating Guide
Type designation
Power losses and efficiency
Estimated power loss at rated maximum load [W]
Efficiency
(2)
For type of fuse see 8.10.2 CE Compliance
1
The typical power loss is at normal load conditions and expected to be within ±15% (tolerance relates to variety in voltage and cable conditions).
Values are based on a typical motor efficiency. Lower efficiency motors also add to the power loss in the drive and conversely. If the switching fre-
quency is raised from nominal, the power losses may rise significantly. LCP and typical control card power consumptions are included. Further op-
tions and customer load may add up to 30 W to the losses. (Though typically only 4 W extra for a fully loaded control card or options for slot A or slot
B, each). Although measurements are made with state-of-the-art equipment, some measurement inaccuracy must be allowed for (±5%).
Measured using 5 m (16.4 ft) shielded motor cables at rated load and rated frequency.
2
Table 54: Mains Supply 3x525–690 V AC, Normal Overload 110% for 1 Minute, P37K–P90K
Type designation
High/normal load
Typical shaft output at 550 V [kW]
Typical shaft output at 690 V [kW]
IP20/UL Open Type
IP21/UL Type 1
IP55/UL Type 12
Output current
Continuous (3x525–550 V) [A]
Intermittent (60 s overload) (3x525–550 V) [A]
Continuous (3x551-690 V) [A]
Intermittent (60 s overload) (3x551–690 V) [A]
Continuous kVA (550 V AC) [kVA]
Continuous kVA (690 V AC) [kVA]
Maximum input current
Continuous (at 550 V) [A]
Intermittent (60 s overload) (at 550 V) [A]
Continuous (at 690 V) [A]
Intermittent (60 s overload) (at 690 V) [A]
Maximum pre-fuses [A]
(1)
SCCR
With mains disconnect [kA
rms
Without mains disconnect [kA
Danfoss A/S © 2023.09
()
and the Fuses and Circuit Breakers section.
]
]
rms
P11K P15K P18K
150 220 300
0.98 0.98 0.98
P37K P45K P55K
NO NO NO
30 37 45
37 45 55
B4 C3 C3
C2 C2 C2
C2 C2 C2
43 54 65
47.3 59.4 71.5
41 52 62
45.1 57.2 68.2
41 51.4 61.9
49 62.1 74.1
49 59 71
53.9 64.9 78.1
48 58 70
52.8 63.8 77
125 160 160
65 kA 65 kA 65 kA
100 kA 100 kA 100 kA
AQ267037536117en-000101 / 130R0083 | 95
Specifications
P22K P30K
370 440
0.98 0.98
P75K P90K
NO NO
55 75
75 90
D3h D3h
C2 C2
C2 C2
87 105
95.7 115.5
83 100
91.3 110
82.9 100
99.2 119.5
87 99
95.7 108.9
86 94.3
94.6 112.7
–
65 kA 65 kA
100 kA 100 kA