Table of Contents
Advertisement
8.4
Setting up the sensor arm
Before starting paving, the sensor arm
must be set, with the grade control sys-
tem, to its reference (cable, kerb, etc.).
Sensing should be carried out in the
A
area of the auger.
- Swivel the sensor arm (2)
over the reference.
- Use the following options to adjust the
sensor arm precisely:
- After
loosening
bolts (3), the sensor arm length can
be set up.
- The sensing height can be set by
loosening the clamping bolts (4).
- Adjustment of the lateral sensing angle is possible at the lock (5).
- Height adjustment for analogue grade sensors is carried out by means of
a crank (6). To lock it, the crank is inserted into one of the available notches fol-
lowing the adjustment work.
All assembly parts and clamping points must be tightened properly to ensure safe and
A
precise sensor arm operation!
- Connect the left or right grade control system connection cable to the intended
handset or vehicle socket.
If the vehicle is to be operated with automatic grade sensing on both sides, the above
A
described adjustment process must be repeated on the second side.
Exhaustive operating instructions can be found in the documentation for the corre-
A
sponding levelling system.
E 13 48
6
4
the
clamping
2
5
3
Advertisement
Table of Contents
