Table of Contents
Advertisement
Installation and operation
CAUTION
CAUTION
- Extend the platform to the side for easy access to the corresponding B-pillar.
- Mount the bracket (1) on the B-pillar on the left / right of the control platform.
Screw the corresponding clamping bolts (2) tight.
- Insert holder (3) in holder (1),
- Insert pipe (4) in holder (3).
- Place the illuminated balloon (5) on the pipe (4) and fix with a clamping bolt (6).
- Adjust the pipe (4) to the required height and fix with a clamping bolt (7).
- With one hand on the handle flagged in green (8), pull down hard to open the bal-
loon before putting it into operation.
When the balloon has been pulled down completely up to the stop, a safety catch
(9) folds out of the guide rod.
- Swivel the holder (3), fix with split pin (10) and the corresponding clamping
bolts (11).
- Once the illuminated balloon is completely mounted, aligned and secured, connect
the plug (12) of the illuminated balloon in the corresponding switch cabinet
sockets (13).
m
Never adjust the holding tube while the illuminated balloon is in operation.
Operation of the switch cabinet - see screed operating instructions.
A
m
Route the supply lines so as to rule out any risk of stumbling or damage to the lines.
D 31 42
Danger due to electric shock
Electric shock can cause severe or fatal injuries
- The Powermoon must always be completely unpacked,
assembled and aligned before it is connected to the
power grid and switched on!
Danger of squeezing!
Fingers or hands can get clamped between the bracket and
the holding tube!
- Caution when inserting the holding tube!
Advertisement
Table of Contents
