Table of Contents
Advertisement
Item Designation
Starter / drive
12
engine OFF
Drive lever
13
(traction)
Brief description
For starting and shutting off the drive engine.
- On actuation, the starter is in operation
- Switch the running engine OFF by pressing
the button again
m
Run the starter continuously for a maximum
of 20 seconds, then take a break for 1 minute!
All emergency stop buttons (on the operating panel and
A
the remote controls) must be pulled out when starting.
For switching on the paver finisher functions and for continu-
ously regulating the road speed – forward or reverse.
Centre position: Engine in neutral; no travel drive;
- To swivel the drive lever out, release by pulling the handle
up.
Depending on the position of the drive lever, the following
functions can be activated:
1. position:
- Conveyor and auger on.
2. position:
- Screed motion (tamper/vibration) on; travel drive on;
increase speed until the stop is reached.
Use the preselector to set the maximum speed.
A
The vehicle speed cannot be reduced to "0" with the
f
preselector. The vehicle advances slightly with deflect-
ed drive lever, even if the travel drive preselector is set
to zero!
If the engine is started with the drive lever pivoted out,
A
the travel drive is inhibited.
To start the travel drive, first the drive lever must be re-
turned to the centre position.
When changing over between forwards and reverse
A
travel, the drive lever must remain briefly in neutral.
D 13 7
Advertisement
Table of Contents
