Table of Contents
Advertisement
Before mounting the auger brace, the required auger height should already have
A
been set on the basic auger!
Note the section "Height adjustment for large operating widths / with brace"!
- Mount the left/right guide plates (1) on the vehicle frame shackles with the relevant
assembly parts (2).
The guide plates must be mounted on the front and rear side of the machine
A
frame shackles.
- Slide the support shackle (3) over the guide plate and secure in the groove with a
pin (4) and split pin (5).
- Mount bracket (6) to the extension pipe (7) using the relevant assembly parts.
Mount the bracket (6) so that the support (3) is at right angles after mounting!
A
- Slide the lower support shackle (3) over the attaching point of the bracket (6) and
secure with a pin (8) and split pin (9).
The brace bracket (10) is secured to the central panel of the machine using the cor-
A
responding assembly parts.
- Insert the fulcrum bracket (11) into the brace bracket (10) and secure with the re-
taining pin (12).
- Secure the retaining pins (12) with a split pin (13).
- Mount braces (14) to the bracket (11) using the relevant assembly parts (15).
The braces must be mounted on the outer side of the fulcrum bracket (11)!
A
- Remove the spring cotter pin (16) and retaining pin (17), pull out the adjustment rod
(18) until the brace can be mounted on the bracket (with shackle) (20) using the re-
taining pin+split pin (19).
- Secure the adjustment rod (18) in an appropriate bore with a retaining pin (17) and
spring cotter pin (16).
- Mount the vertical brace (21) to the bracket (20) in the same way.
At the support (3) mounting point, the brace must be secured at the rear side
A
in each case!
E 13 38
Advertisement
Table of Contents
