Fayat Group DYNAPAC SC2500WS Operating Instructions Manual page 315

1.4 Starting for paving
Set the switches, levers and controls listed below to the specified positions when the
screed has reached its operating temperature and a sufficient amount of material lies
in front of the screed
Item
13 Drive lever
33 Traction drive fast/slow
15 Travel drive preselector
Preparation for screed floating posi-
70
tion
72 Vibration
71 Tamper
53/54
Auger left/right
123
47/48
Conveyor left/right
127
126 /
Levelling
130
Speed regulator, vibration
Speed control for the tamper
- Push the drive lever (13) all the way to the front and start driving.
- Observe the distribution of the material and adjust the limit switches if necessary.
- Set the compacting elements (tamper / vibration) according to the required com-
paction ratio.
- Let the paving master check the paving thickness after 5–6 meters and correct
if necessary.
Carry out the check in the area of the caterpillar chains or drive wheels as the screed
tends to level an uneven ground. The reference points for the layer thickness are the
caterpillar chains or drive wheels.
The basic setting of the screed must be corrected when the actual layer thickness de-
viates significantly from the values indicated by the scales (see the operating instruc-
tions for the screed).
The basic setting is for asphalt material.
A
Travelling direction Position
Centre position
LED OFF
Mark 6-7
LED ON
LED ON
LED ON
auto
auto
auto
adapted to the paving situation
adapted to the paving situation
D 43 25