Table of Contents
Advertisement
- Once the sensor rod has been set to the desired width, the clamping bolts (2) must
be tightened again.
- The inserted sensor rod extension is secured with the bolts (4).
Depending on the side of the vehicle on which the sensor rod extension is used, the
A
entire sensor rod may have to be removed and re-inserted on the other side of
the vehicle!
- After releasing the wing nuts (5), the end section of the sensor rod extension (6)
can be set to the desired length; the angle can additionally be changed by swivel-
ling on the joint (7).
Either the adjustable indicator or the chain can be used as an aid to orientation.
A
m
Tighten all assembly parts properly after setting up!
The sensor rod extension's joint (7) can be mounted on both sides of the vehicle in
A
position (8).
At this point, the sensor rod extension can be swivelled in for transporting the vehicle
without increasing the vehicle's basic width.
D 31 25
Advertisement
Table of Contents
