Hartmann Veroval Compact+ Instructions For Use Manual page 13

EN English
Average values
• After selecting the respective user memory, the corresponding
symbol or and an ' ' appear on the display. The average
value of all the data stored for that particular user memory
is displayed.
• By pressing the button again (or the button if you
are in user memory 2), the average values for all morning
measurements ' ' (00:00 to 11:59) for the past 7 days
(including the current day) appear.
IFU_9252050_020323.indd 24-25 IFU_9252050_020323.indd 24-25
• By pressing the button again (or the button if you
are in user memory 2) the average values for all evening
measurements ' ' (12:00 to 23:59) for the past 7 days
(including the current day) appear.
• If there is no morning or evening value for the past 7 days
in the memory, dashes will be shown on the display instead
of the morning or evening average values. If no values at all
are stored in the memory, then dashes will also be displayed
instead of the overall average value.
24
Individual measured values
• By pressing the button again (or the button if you are in
user memory 2), all memory values can be retrieved one after
the other, starting with the most recently measured value.
• In order to distinguish a single measurement from a multiple
measurement, the ' ' symbol and the date are displayed
alternately for a value that was measured in expert mode.
English
• If an irregular heartbeat was detected during measurement, that
information is also stored and displayed when the measured
value is retrieved from the device's memory along with the systolic and
diastolic blood pressure readings, pulse rate, time, date and year.
• You can cancel memory recall at any time by pressing the START/STOP
button . Otherwise, the device will switch off automatically after
a few seconds.
• Even if the power supply is interrupted, e.g. when changing the
batteries, the stored values will still be available.
Deleting saved readings
All data saved for each user can be deleted separately for user memory and user
memory . To do so, press the button of the corresponding user memory ( or ). The
average value ' ' is then shown on the display.
Press and hold the user memory button for 5 seconds. ' ' appears on the display.
All data in the selected user memory are now deleted. If you release the button early,
no data will be deleted.
25
EN
02.03.23 10:42 02.03.23 10:42