Table of Contents
Advertisement
SIS Configuration
and Control
This section describes the remote control operation of the FOX3 T 101 transmitter and
FOX3 R 101 receiver, including:
•
•
•
The FOX3 transmitter and receiver can be configured using SIS commands, PCS, or the
embedded web page. The FOX3 devices can be controlled using SIS commands or PCS.
Configure and control the FOX3 devices remotely via a host computer or other device (such
as a control system) by connecting to the front panel USB port of the FOX3 device.
NOTE: SIS commands and Product Configuration Software functions are transmitter
Host Control Ports
The front panel USB-C Configuration port (see
can be connected to a host computer for configuration using SIS commands via an SSH
client and IP address 203.0.113.22 on port 22023.
Establishing a Connection
Establish a network connection to a FOX3 device as follows:
1.
2.
3.
4.
5.
Host Control Ports
Simple Instruction Set Control
Command and Response Table for SIS Commands
and receiver specific or may have different responses depending on the unit
connected. Connect to the appropriate device for the command to work properly or to
get the expected response.
Download the SSH software.
Open the SSH software.
Enter the IP address of the FOX3 device in the Host Name or IP address field.
NOTE: The IP address is 203.0.113.22. It cannot be changed.
Enter 22023 in the Port field.
The FOX3 device is password protected, so the appropriate name, admin or user, and
password must be entered.
•
If the login and password are correct, the device responds with a copyright
message including the copyright year, the name of the product, firmware version,
part number, and the current date and time.
•
If the login and password are incorrect, the Login prompt returns. Enter the admin
or user name and password again.
FOX3 T 101 Transmitter and FOX3 R 101 Receiver • SIS Configuration and Control
figure 6
and figure 7,
on page 9)
B
12
Advertisement
Table of Contents
