Installing The Chassis Into The Rack; Removing The Chassis From The Rack - Supermicro SuperServer SYS-110D-4C-FRAN8TP User Manual

2.5 Installing the Chassis into the Rack

1. Confirm that the chassis includes the inner rails and rail extensions. Also, confirm that
the outer rails are installed on the rack.
2. Align the chassis rails with the front of the rack rails.
3. Slide the chassis rails into the rack rails, keeping the pressure even on both sides.
(It may be necessary to depress the locking tabs when inserting). When the server
has been pushed completely into the rack, the locking tabs will "click" into the locked
position.
4. Insert and tighten the screws that hold the front of the server to the rack.
Note: Figures are for illustrative purposes only. Always install servers to the bottom of a rack
first.

2.6 Removing the Chassis from the Rack

1. Pull the chassis by the inner rail handles until the chassis is stopped by the locking tabs.
2. Press down on the locking tab while holding both side of the chassis.
3. Pull the chassis completely out of the rack.
Figure 2-4. Installing the Server into a Rack
27
Chapter 2: Server Installation