Supermicro SuperServer SYS-110D-4C-FRAN8TP User Manual page 63

ME Manufacturing Mode
Close pins 2-3 of jumper JPME2 to bypass SPI flash security and force the system to operate
in the manufacturing mode, which will allow the user to flash the system firmware from a host
server for system setting modifications. Refer to the table below for jumper settings.
OCuLink Selection
Use JNS1 to select the OCuLink lane. Refer to the table below for lane options.
Onboard TPM Enable/Disable
Use JPT1 to enable or disable the onboard TPM.
VGA Enable/Disable
JPG1 allows you to enable or disable the VGA port using the onboard graphics controller.
ME Manufacturing Mode
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal (Default)
Pins 2-3 Manufacturing Mode
OCuLink Selection
Jumper Settings
Jumper Setting Definition
Pins 1-2 4x SATA
Pins 2-3 PCIe x4
Onboard TPM Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
VGA Enable/Disable
Jumper Settings
Jumper Setting Definition
Pins 1-2 Enabled
Pins 2-3 Disabled
63
Chapter 4: Motherboard Connections