Supermicro SuperServer SYS-110D-4C-FRAN8TP User Manual page 46

3. Disconnect the power cord from the power strip or outlet.
4. Disconnect the power cord from the power supply inlet.
5. Push the release button towards the handle.
6. Using the handle, pull the power supply out of the chassis.
7. Slide the new power supply into the chassis until it clicks into place.
8. Reconnect the power cord to the power supply inlet.
9. Reconnect the power cord to the power strip or outlet.
10. Check the power supply's LED.
11. Use remote management to check the power supply status.
Note: The figure above is intended to show the power supply locations only. The chassis and
serverboard may differ from those found in the SYS-110D-4C/8C/14C/16C/20C-FR(A/D)N8TP.
Chapter 3: Maintenance and Component Installation
Release Button
Figure 3-13. Removing the Power Supply
46