Teledyne Linea GigE LA-GM-04K08A User Manual page 44

Pulse on: Input Line 3
Event
Pulse on: Input Line 4
Event
Pulse on: Rotary Encoder 1
Pulse on: Software
Command
Frame Trigger
Frame Valid
Exposure Active
Line Active
Smart Strobe Active
Output Line Pulse Signal
Activation
Rising Edge
Falling Edge
Any Edge
Output Line Pulse Delay
Output Line Pulse Duration
Output Line Software Latch
Control
Off
Output Line Value
Active
Inactive
Line Status All
Output Line Software
Command
42 • Operational Reference
PulseOnInput3
PulseOnInput4
PulseOnRotaryEncoder1
PulseOnSoftwareCmd
FrameTriggerActive
FrameActive
ExposureActive
ReadoutActive
SmartStrobeActive
outputLinePulseActivation
RisingEdge
FallingEdge
AnyEdge
outputLinePulseDelay
outputLinePulseDuration
outputLineSoftwareLatchControl
Off
outputLineValue
Active
Inactive
LineStatusAll
outputLineSoftwareCmd
Generate a pulse on the Input signal 3 event
Generate a pulse on the Input signal 4 event
Generate a pulse on the Rotary Encoder 1 event
Generate a pulse on the Input of a Software Command
Generate a signal that is active when the frame trigger is
active
Generate a signal that is active when the Frame is active
Generate a signal that is active when the Exposure is active
Generate a signal that is active when the line valid is active
Generate a signal that is active when the Readout or the
ExposureDelay are active. The smart strobe only works when
triggerLineCount is greater than 1
Specifies the input line activation mode to trigger the
OutputLine pulse.
Specifies that the trigger is considered valid on the rising
edge of the source signal.
Specifies that the trigger is considered valid on the falling
edge of the source signal.
Specifies that the trigger is considered valid on the falling or
rising edge of the source signal.
Sets the delay (in µs) before the output line pulse signal.
Applicable for the OutputLineSource feature. Note, the
LineMode feature must be set to output.
Sets the width (duration) of the output line pulse in
microseconds.
When Off, the selected output line is set with the value in
Output Line Value. (RO)
Output pin state set by outputLineValue.
Sets the output state of the selected Line if the
outputLineSoftwareLatchControl = OFF. OutputLineSource
must be SoftwareControlled. If the
outputLineSoftwareLatchControl = Latch , the state of the pin
will change with the outputLineSoftwareCmd command.
Sets the Output circuit to close
Sets the Output circuit to open
Returns the current status of all available line signals, at time
of polling, in a single bitfield. The order is Line1, Line2,
Line3, ... (RO)
Writing a value of 1 in the bit field applies the Latch value of
the outputLineSoftwareLatchControl and/or executes the
PulseOnSoftwareCmd for any output line programmed for
software control. The feature outputLineSoftwareCmd can
take any binary value and each bit set to 1 corresponds to a
Icommand for an Output.
Bit-0 is Line 3,
Bit-1 is Line 4,
Bit-2 is Line 5,
Bit-3 is Line 6
This is applicable to OutputLineSource = Pulse On: where
Software Cmd (for Pulse mode) or OutputLineSource =
SoftwareControlled and OutputLineSoftwareLatchControl =
Latch (for static states).
1.00
Beginner
DFNC
1.00
Beginner
DFNC
1.00
Beginner
DFNC
1.00
Guru
DFNC
1.00
Beginner
DFNC
1.00
Expert
1.00
Expert
DFNC
Linea GigE Series Camera