Table of Contents
Advertisement
Device User ID
Power-up Configuration
Selector
None
Factory Setting
UserSet1
UserSet2
UserSet3
UserSet4
User Set Selector
Factory Setting
UserSet 1
UserSet 2
UserSet 3
UserSet 4
Load Configuration
Save Configuration
Device Built-In Self Test
Device Built-In Self Test
Status
Passed
Firmware update failed
FPGA Cyclic Redundancy
Check Failed
Unexpected Error
Device Built-In Self Test
Status All
Device Reset
Device Temperature
Selector
FPGA Board
Device Temperature
30 • Operational Reference
DeviceUserID
UserSetDefault
None
Default
UserSet1
UserSet2
UserSet3
UserSet4
UserSetSelector
Default
UserSet1
UserSet2
UserSet3
UserSet4
UserSetLoad
UserSetSave
deviceBIST
deviceBISTStatus
Passed
FirmwareUpdateFailure
FPGA_CRC_Failure
Unexpected_Error
deviceBISTStatusAll
DeviceReset
DeviceTemperatureSelector
FPGABoard
DeviceTemperature
Feature to store a user-programmable identifier of up to 15
characters. The default factory setting is the camera serial
number. (RW)
Selects the camera configuration set to load and make active
on camera power-up or reset. The camera configuration sets
are stored in camera non-volatile memory. (RW)
Keep Internal configuration.
Load factory default feature settings.
Select the user defined configuration UserSet 1 as the Power-
up Configuration.
Select the user defined configuration UserSet 2 as the Power-
up Configuration.
Select the user defined configuration UserSet 3 as the Power-
up Configuration.
Select the user defined configuration UserSet 4 as the Power-
up Configuration.
Selects the camera configuration set to load feature settings
from or save current feature settings to. The Factory set
contains default camera feature settings. User camera
configuration sets contain features settings previously saved
by the user. (RW)
Select the default camera feature settings saved by the
factory.
Select the User Defined Configuration space UserSet1 to save
to or load from features settings previously saved by the user.
Select the User Defined Configuration space UserSet2 to save
to or load from features settings previously saved by the user.
Select the User Defined Configuration space UserSet3 to save
to or load from features settings previously saved by the user.
Select the User Defined Configuration space UserSet4 to save
to or load from features settings previously saved by the user.
Loads the camera configuration set specified by the User Set
Selector feature, to the camera and makes it active. (W)
Saves the current camera configuration to the user set
specified by the User Set Selector feature. The user sets are
located on the camera in non-volatile memory. (W)
Command to perform an internal test which will determine the
device status. (W)
Return the status of the device Built-In Self test. Possible
return values are device-specific.
No failure detected
Last firmware update operation failed.
FPGA cyclic redundancy check failed.
Switched to recovery mode due to unexpected software error.
Return the status of the device Built-In Self Test as a bitfield.
The meaning for each bit is device-specific.
Resets the device to its power up state. (W)
Select the source where the temperature is read.
Read FPGA Board temperature
The temperature of the selected source in degrees Celsius
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
DFNC
Beginner
1.00
Beginner
1.00
DFNC
Beginner
1.00
Beginner
1.00
Beginner
1.00
Beginner
Linea GigE Series Camera
Advertisement
Table of Contents
