Teledyne Linea GigE LA-GM-04K08A User Manual page 42

Rotary Encoder Direction
Clockwise
Counter Clockwise
Rotary Encoder Input A
Source
Line 1
Line 3
Rotary Encoder Input B
Source
GND
Line 2
Line 4
Rotary Encoder Source
Activation
Rising Edge
Any Edge
Rotary Encoder Rescaler
Order
Multiplier Divider
Divider Multiplier
Rotary Encoder Multiplier
Rotary Encoder Divider
Line Selector
Line 1
Line 2
Line 3
Line 4
Line 5
Line 6
Line Format
SingleEnded
Open Collector
RS422
Line Mode
Input
Output
40 • Operational Reference
rotaryEncoderDirection
Clockwise
CounterClockwise
rotaryEncoderInputASource
Line1
Line3
rotaryEncoderInputBSource
GND
Line2
Line4
rotaryEncoderSrcActivation
RisingEdge
AnyEdge
rotaryEncoderRescalerOrder
multiplierDivider
dividerMultiplier
rotaryEncoderMultiplier
rotaryEncoderDivider
LineSelector
Line1
Line2
Line3
Line4
Line5
Line6
LineFormat
SingleEnded
OpenCollector
RS422
LineMode
Input
Output
Specifies the phase which defines the encoder forward
direction.
Inspection goes forward when the rotary encoder direction is
clockwise (phase B is ahead of phase A).
Inspection goes forward when the rotary encoder direction is
counter clockwise (phase A is ahead of phase B).
Selects which input line to assign to the rotary encoder input
A (also known as shaft encoder). Note that the Line Mode
feature must be set to Input. The list of supported input line
sources is device-specific.
Line1 is assigned to the Rotary Encoder Input A
Line3 is assigned to the Rotary Encoder Input A
Selects which input line to assign to the rotary encoder input
B (also known as shaft encoder). Note that the Line Mode
feature must be set to Input. The list of supported input line
sources is device-specific.
Rotary Encoder Input B is not used
Line2 is assigned to the Rotary Encoder Input B
Line4 is assigned to the Rotary Encoder Input B
Specifies the signal edge(s) use to increment the rotary
encoder.
The rotary encoder uses the rising edge of the source signal.
The rotary encoder uses either the rising edge or falling edge
of the source signal.
Specifies the order that the multiplier and divider are applied.
The signal is multiplied before been divided.
The signal is divided before been multiplied.
Specifies a multiplication factor for the rotary encoder output
pulse generator.
Specifies a division factor for the rotary encoder output pulse
generator.
Selects the physical line (or pin) of the external device
connector to configure.
Index of the physical line and associated I/O control block to
use.
Specify the current electrical format of the selected physical
input or output. Applies to all physical lines. (RO)
The line is single ended input for 3.3V/5V/12V/24V or output
for 3.3V LVTTL
The line is output as open collector.
The line accepts or sends RS422 level signals.
Reports if the physical Line is an Input or Output signal. (RO)
See Input Signals Electrical Specifications.
See Output Signals Electrical Specifications.
The line is an input line.
The line is an output line.
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Guru
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Beginner
1.00
Expert
1.00
Expert
Linea GigE Series Camera