Resetting A Host - BenQ InstaShow VS10 User Manual

Resetting a Host

Resetting a Host allows you to return the Host to its original factory settings. You may
want to reset the Host because of either one of the following reasons:
• You want to clear the web management interface of all changes made to its
configurations, such as pairing information, passwords, SSID, etc. and return it back to
its default settings. Refer to
• You are unable to access the web management interface (for instance due to an altered
or lost password).
Reset the Host using the following steps:
1. Connect the power port on the Host to a power source and wait for at least 90 seconds.
After the Host has been connected to a power source for at least 90 seconds, the Host LED may
indicate any one of the statuses described in
As long as the Host has been connected to a power source for at least 90 seconds, you may proceed
to the next step of the resetting process regardless of the status of the Host LED.
2. Poke the RESET hole at the rear of the Host with a pin for at least 5 seconds and then
stop.
3. The Host LED will begin quick flashing red (flash red twice every second) for 10 seconds,
then light up static white for 3 seconds, indicating that the Host is resetting.
4. Once the Host LED lights up static green the resetting process is complete.
Do not disconnect the Host from its power source at any time during the resetting process.
Web management on page 48
LED indicators of the Button and the Host on page
31
for more information.
12.