Resetting A Button - BenQ InstaShow VS10 User Manual

Resetting a Button

Resetting a Button allows you to return the Button to its original factory settings. You may
want to reset a Button because of either one of the following conditions:
• You purchased an additional Button (via a Button Kit) which has not been paired to a
Host.
• A Button that was included in the original package has been paired to a different Host
(one which was not originally included with the Button in the package), and you want to
quickly pair it back to its original Host.
• A Button that was included in the original package has been paired to a different Host (one
which was not originally included with the Button in the package), and you want to re-pair
the Button to its original Host while the Host is not powered on.
Reset a Button using the following steps:
1. Connect the USB connector on the Button to a powered-on laptop and wait for at least 30
seconds.
After the Button has been connected to a powered on laptop for at least 30 seconds, the Button LED
may indicate any one of the statuses described in
12. As long as the Button has been connected to a powered on laptop for at least 30 seconds, you
may proceed to the next step of the resetting process regardless of the status of the Button LED.
2. Poke the RESET hole at the bottom of the Button with a pin for at least 5 seconds.
3. The Button LED will begin quick flashing red (flash red twice every second) for 10
seconds, then light up static white for 2 seconds, indicating that the Button is resetting.
4. Once the Button LED lights up static green the resetting process is complete.
Do not disconnect the Button from its power source at any time during the resetting process.
LED indicators of the Button and the Host on page
32